Setting/Releasing The Limiters - Panasonic AW-HE100E Operating Instructions Manual

Setting/releasing the limiters

Basic limiter operations
1
Press the [MENU] button.
Tap the button (rather than pressing it). When it is
pressed for two seconds, a menu will appear.
If this happens, press the [MENU] button again for two
seconds to clear the menu.
Then start again from step
2
Press the [], [], [] or [] button for
two seconds while holding down the
[PRESET] button.
The limiter for the upper limit, lower limit, left limit or
right limit is set (or released) using these direction
buttons, respectively.
The tally lamp will blink at this time.
When a limiter is set, it blinks once; when a limiter is
released, it blinks twice.
If any other button was operated between steps
2
, start again from step
Setting the limiters
The limiter positions can be set by following the steps below.
When the position is set, the tally lamp blinks once.
1
Press one of the [CAM1] to [CAM4]
buttons to select the unit.
 Setting the upper limit position of the movement
range
Press the [] or [] button of the wireless remote
control to turn the unit as far as the position which
will serve as the upper limit.
Next, perform the steps in "Basic limiter operations",
and press the [] button for two seconds while
holding down the [PRESET] button.
 Setting the lower limit position of the movement
range
Press the [] or [] button of the wireless remote
control to turn the unit as far as the position which
will serve as the lower limit.
Next, perform the steps in "Basic limiter operations",
and press the [] button for two seconds while
holding down the [PRESET] button.
 Setting the left-most limit position of the
movement range
Press the [] or [] button of the wireless remote
control to turn the unit as far as the position which
will serve as the left-most limit.
Next, perform the steps in "Basic limiter operations",
and press the [] button for two seconds while
holding down the [PRESET] button.
1
.
1
and
1
.
 Setting the right-most limit position of the
movement range
Press the [] or [] button of the wireless remote
control to turn the unit as far as the position which
will serve as the right-most limit.
Next, perform the steps in "Basic limiter operations",
and press the [] button for two seconds while
holding down the [PRESET] button.
Releasing the limiters
The limiter positions that are set can be released by
following the steps below.
When the position is released, the tally lamp blinks twice.
1
Press one of the [CAM1] to [CAM4]
buttons to select the unit.
2
Release the limiters by taking the steps
below.
 Releasing the upper limit position of the
movement range
Perform the steps in "Basic limiter operations", and
press the [] button for two seconds while holding
down the [PRESET] button.
 Releasing the lower limit position of the
movement range
Perform the steps in "Basic limiter operations", and
press the [] button for two seconds while holding
down the [PRESET] button.
 Releasing the left-most limit position of the
movement range
Perform the steps in "Basic limiter operations", and
press the [] button for two seconds while holding
down the [PRESET] button.
 Releasing the right-most limit position of the
movement range
Perform the steps in "Basic limiter operations", and
press the [] button for two seconds while holding
down the [PRESET] button.
Resetting the limiters
To reset the limiters, the currently established settings must
be released.
The limiter positions that are set can be reset by following
the steps below.
1
Release the settings of the limiter
positions to be reset by following the
steps in "Releasing the limiters".
2
Set the limiter positions by following the
steps in "Setting the limiters".
58 (E)