Input Program; End Program - Yamato DNF 400 Instruction Manual

Input Program; End Program

End program procedure
1
① Select the "Program End" and press the ENTER key. The program edition is completed.
② The program edition has not done if the POWER or CANCEL key is pressed before pressing the
"Program End" at the end of program edition.
③ Make sure to press the "Program End" after program edition.
The "Program End" can be set at any steps in addition to at the edition step.
Program End
S01
TROUBLE
ENTER CANCEL
DOOR
→
2002/01/01
35
Operation Method
Standby
12:00