Program Operation - Yamato DNF 400 Instruction Manual

Program Operation

As shown in the figure, this mode is used for running the device under the setting program.
Start pv
(Temperature)
Start program
Setting of the Program Operation
Turn on the power
1
FIXED TEMP
AUTO STOP
AUTO START
PROGRAM
STANDBY
END
HEATER
FUNCTION PROGRAM
FAN
Program registration using PROGRAM key is necessary before starting program operation.
Select operation mode
2
FIXED TEMP
AUTO STOP
AUTO START
PROGRAM
STANDBY
END
HEATER
FUNCTION PROGRAM
FAN
Step1 Step2 Step3
POWER
Standby DOOR
℃ 2002/01/01 12:00
TROUBLE
MENU ENTER CANCEL
MENU
DOOR
Program OPR
℃
Select OPR mode
TROUBLE
MENU ENTER
CANCEL
Step4 Step5 Step6
• Turn on the power switch of the unit (earth leakage
breaker). Pressing the POWER key turns on the
power. The
temperature in furnace.
indicates "Standby" and the STANDBY lamp lights
on. (Hereafter, this state is called the "standby
state".)
• The FAN lamp lights on and the fan rotates when
"Standby" is displayed. Refer to the page 50 to
SUBMENU
stop the rotation of fan.
POWER
① Pressing the MENU key displays the operation
mode selection screen.
② The Sub Display on the operation mode selection
screen displays the name of operation mode
currently selected
corresponding operation mode lamp blinks at the
same time.
③ Keep pressing the MENU key until the program
SUBMENU
operation mode is displayed.
④ Press the ENTER key. The program operation
POWER
mode is decided.
The fixed temperature operation is selected at the
initial setting of unit. The operation mode carried
out last is selected in case other than it.
22
Operation Method
Setting
temperature
Step7 Step8
(Time)
End program
Main Display indicates
The Sub Display
with blinking.
the
The