Input Program; Add Step - Yamato DNF 400 Instruction Manual

Input Program; Add Step

Step addition procedure
1
① Display the setting of un-used step on the setting item selection screen and then press the
ENTER key.
The "SO1" (the first step) indicates "un-used" at the first registration of program.
The items other than "Insert step", "Delete step" and "End program" can be set.
The "un-used" steps are not displayed if no steps are left.
② Change the setting value and press the ENTER key.
③ The indication "un-used" on the lower column of Sub Display goes out.
④ Set the other items respectively.
⑤ Press the PROGRAM key to display the next selection screen after step addition is completed.
Set TEMP 0℃
S23(un-used)
TROUBLE
ENTER CANCEL
Set TEMP 0℃
S23
TROUBLE
ENTER CANCEL
33
Operation Method
DOOR
DOOR