Fixed Temperature Operation - Yamato DNF 400 Instruction Manual

Fixed Temperature Operation

Start the operation from turning on the power shown in the figure, and continue the operation
under the setting temperature unless turning off the power.
SV
START
Setting of the Fixed Temperature Operation
Turn on the power
1
FIXED TEMP
AUTO STOP
AUTO START
PROGRAM
STANDBY
END
HEATER
FUNCTION PROGRAM
FAN
Select operation mode
2
FIXED TEMP
AUTO STOP
AUTO START
PROGRAM
STANDBY
END
HEATER
FUNCTION PROGRAM
FAN
▲
POWER
Standby DOOR
℃ 2002/01/01 12:00
TROUBLE
MENU ENTER CANCEL
MENU
DOOR
Fixed TEMP OPR
℃
Select OPR mode
TROUBLE
MENU ENTER CANCEL
t
▲
STOP
• Turn on the power switch of the unit (earth leakage
breaker). Pressing the POWER key turns on the
power. The
temperature in furnace.
indicates "Standby" and the STANDBY lamp lights
on. (Hereafter, this state is called the "standby
state".)
• The FAN lamp lights on and the fan rotates when
"Standby" is displayed. Refer to the page 50 to
SUBMENU
stop the rotation of fan.
POWER
① Pressing the MENU key displays the operation
mode selection screen.
② The Sub Display on the operation mode selection
screen displays the name of operation mode
currently selected
corresponding operation mode lamp blinks at the
same time.
③ Keep pressing the MENU key until the fixed
SUBMENU
temperature operation mode is displayed.
④ Press the ENTER key.
POWER
operation mode is decided.
The fixed temperature operation is selected at the
initial setting of unit. The operation mode carried
out last is selected in case other than it.
15
Operation Method
SV: Setting temperature
t: Time
Main Display indicates
The Sub Display
with blinking.
The fixed temperature
the
The