Input Program; Insert Step
Step insertion procedure
1
① Select the "Insert step" and then press the ENTER key. A step is added there.
ENTER
The newly added step is inserted into the step number which is displayed on the selection screen. The
sequence number of each registered step hereafter increases according to the number of steps added.
The initial settings below are set in the newly inserted step. The settings of "un-used" steps displayed
at the end of "Select step" are the same as that listed below.
② Select the time using "▼▲" and press the ENTER key. The setting is decided and the screen
returns to the setting item selection screen.
③ Press the PROGRAM key to display the next selection screen after the step insertion is
completed.
Insert step
S03
(Selection screen)
Item
Setting temperature
Setting time
Rotation speed of fan
Repeat initiating step
32
Operation Method
Set TEMP
S03
→
(Selection screen for
step inserted)
Initial setting
0℃
0 minute
10
No
►0℃