Input Program; Delete Step - Yamato DNF 400 Instruction Manual

Input Program; Delete Step

Step deletion procedure
1
① Press the program key. The program menu starts and step number selection screen is displayed.
Press the "▼▲". The registered step numbers and the smallest number of un-used step are
displayed in sequence. Select the step number to be deleted.
② Press the ENTER key.
③ Press the PROGRAM key and select "Delete step".
④ Press the ENTER key. The selected step is deleted and the "Program End" screen is displayed.
⑤ Press the ENTER key to end the program edition if the step to be deleted is correct.
⑥ The unit enters into standby state where step deletion is completed.
PROGRAM
→
Delete step
S01
TROUBLE
ENTER
CANCEL
2002/01/01
Select step S01
Program OPR
ENTER
ENTER
PROGRAM
DOOR
Program End
→
S01
ENTER
Standby
12:00
34
Operation Method
DOOR
TROUBLE
CANCEL