Auto Stop Operation - Yamato DNF 400 Instruction Manual

Auto Stop Operation

As shown in the following figure, the device stops operating automatically by setting the timer.
SV
Start operation (manual)
Setting of the Auto Stop Operation
Turn on the power
1
FIXED TEMP
AUTO STOP
AUTO START
PROGRAM
STANDBY
END
HEATER
FUNCTION PROGRAM
FAN
Select operation mode
2
FIXED TEMP
AUTO STOP
AUTO START
PROGRAM
STANDBY
END
HEATER
FUNCTION PROGRAM
FAN
Set timer
▼
Waiting Operation
period
Activate timer
Stop operation (auto)
POWER
Standby DOOR
℃ 2002/01/01 12:00
TROUBLE
MENU ENTER CANCEL
MENU
DOOR
Auto-stop OPR
℃
Select OPR mode
TROUBLE
MENU ENTER CANCEL
t
• Turn on the power switch of the unit (earth leakage
breaker). Pressing the POWER key turns on the
power. The
temperature in furnace.
indicates "Standby" and the STANDBY lamp lights
on. (Hereafter, this state is called the "standby
state".)
• The FAN lamp lights on and the fan rotates when
"Standby" is displayed. Refer to the page 50 to
SUBMENU
stop the rotation of fan.
POWER
① Pressing the MENU key displays the operation
mode selection screen.
② The Sub Display on the operation mode selection
screen displays the name of operation mode
currently selected
corresponding operation mode lamp blinks at the
same time.
③ Keep pressing the MENU key until the auto stop
SUBMENU
operation mode is displayed.
④ Press the ENTER key. The auto stop operation
POWER
mode is decided.
The fixed temperature operation is selected at the
initial setting of unit. The operation mode carried
out last is selected in case other than it.
17
Operation Method
SV: Setting temperature
t: Time
Main Display indicates
The Sub Display
with blinking.
the
The