Salt Indicator; Bypassing The Salt Indicator Lamp - Miele G 879 SCVI Operating And Installation Instructions

Salt indicator.

When the salt reservoir is empty, the
" k" indicator lamp will light, notif-
8
ying you that the reservoir should be re-
filled with reactivation salt.
Once filled, the dishwasher will automati-
cally reactivate the softener when
necessary. The "
8
will light up whenever the reactivation
process is being performed.
Note:
If the water used is very soft (below 150
ppm (mg/l)), further softening is not re-
quired and the "
8
lamp will remain lit. It can be disre-
garded or bypassed using the follow-
ing procedure.
The " k" button has also been de-
8
signed for future programme updates
(PC). See the "After Sales Service" sec-
tion for further details.
k" indicator lamp
k" indicator

Bypassing the Salt indicator lamp.

In order to bypass the salt indicator
lamp, you will need a screwdriver and
needle nose pliers.
Remove ONLY the salt reservoir cap.
Looking into the salt reservoir, you will
see the top of the float chamber on the
b
right hand side
Using a screwdriver, carefully pivot
the float chamber towards the center
of the reservoir.
Using the needle nose pliers, first
c
pull the cap
ber, then remove the float
Replace the float chamber cap,
push the chamber back into its up-
right position, and replace the salt
reservoir cap. The indicator lamp will
now remain off.
Water Softener
.
off of the float cham-
d
.
17