To Programme The Water Hardness - Miele G 879 SCVI Operating And Installation Instructions

To programme the water hardness,

proceed as follows:
Open the door.
Turn off the dishwasher.
Press and hold buttons
while simultaneously turning on the
dishwasher. The "ON" indicator lamp
will light and the "
lamps will flash.
The " k" indicator lamp will
8
flash as long as you are in the pro-
gramming mode.
If any other indicator lamps flash, turn
off the dishwasher and start again.
Depending upon what "Additional Fea-
tures" are currently programmed into
your machine, other indicator lamps
may also illuminate. These should be ig-
nored for the time being.
Press Touch pad
entry mode. The
stop flashing and go out. (Exception: if
a hardness level of 90 -110 ppm
(mg/l) has been set previously , the
indicator lamp will stop flashing and re-
main lit).
b d
and
c
k"and
8
c
to enter the data
c
indicator lamp will
A)If your Water hardness is 220 ppm
(mg/l) or less, press the touch pad
that corresponds to the level you
want to set (see the Programming
Table on the previous page). As long
as the selected pad is depressed, its
indicator lamp will remain lit. When
the touch pad is released, the
lamp will once again flash.
OR
B) If your Water hardness is greater than
220 ppm (mg/l), press 2 to access
programme level 2 first (its indicator
will light), then press the required
numeric touch pad. Once the numeric
pad is released, the
flash.
Example:
If the water hardness is 450 ppm (mg/l),
press 2 first, then press the
pad. When
tor will flash.
Press 2 once to enter the setting; its
indicator will light up.
Press 2 once more to store the set-
c
ting in memory. The 2 indicator will
flash if the value has been stored cor-
rectly.
Turn off the dishwasher. The water
hardness is now programmed.
Water Softener
c
will once again
e
e
is released, the
c
touch
c
indica-
13