Miele G 879 SCVI Operating And Installation Instructions page 57

Installing the bracket on the rear of
the custom door panel.
Push the dishwasher into its opening
and adjust the height.
Measure the distance "X" between
the round hole in the machine outer
door panel (shown in inset) and the
lower edge of the adjoining cabinet
door.
Place the door panel on a flat sur-
face, good side face down, being
careful not to scratch the surface.
Make certain that the bottom of the
panel is towards you.
Using a pencil, lightly draw a vertical
centerline on the panel (See the illus-
tration on the next page).
Draw a horizontal line "X" inches up
from the bottom edge of the panel.
Dishwasher installation
For two-piece panels:
If your two-piece panel is joined
together using hardware that is not
flush with the rear of the panel, this
hardware must be removed before pro-
ceeding. The mounting bracket sup-
plied with the machine can be used to
secure both pieces to the dishwasher.
When mounting the two pieces,
make sure that the desired finished
panel height is maintained.
57