Glass Replacement - Napoleon HYBRID 150 Installation And Operating Instructions Manual

68
Burn only dry, clean unpainted wood that has been seasoned. It produces more
heat and less soot or creosote. Freshly cut wood contains about 50% moisture
while after proper seasoning only about 20% of the
water remains. As wood is burned, this water boils
EN
off consuming energy that should be used in heating.
The wetter the wood, the less heat is given off and
the more creosote is produced. Dry fi rewood has
cracks in the end of the grain.
Both hardwood and softwood burn equally well in this
appliance but hardwood is denser, will weigh more
per cord and burn a little slower and longer.
Firewood should be split, stacked in a manner that air can get to all parts of it and covered in early spring to be ready for
burning that fall. Dry fi rewood has cracks in the end grain.
Cut the wood so that it will fi t horizontally, front to back, making for easier loading and less of a likelihood that the wood will roll
onto the glass.
Manufactured fi relogs made by compressing 100% natural wood fi bre can be safely used as fuel. Do not use manufactured
fi relogs if they contain additives such as paraffi n, wax, binders etc. Never burn more than two manufactured fi relogs at a time.
DO'S
• Build a hot fi re.
• Use only dry wood.
• Several pieces of medium sized wood are better
than a few big pieces.
• Clean chimney regularly.
• Refuel frequently using medium sized wood.
• "Fine Tune" the air settings for optimum
performance.
9.6

GLASS REPLACEMENT

CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
1. When the appliance is cool, open the door and place the door
frame down careful not to scratch the paint.
2. Remove the screws and brackets holding the glass in place.
Remove all broken glass.
3. Wrap the edges of the new glass with a U-shaped strip of
fi berglass gasket, covering 1/4" (6mm) on each side.
4. Place the glass with the fi berglass gasket in position and replace
the brackets and screws. When fi nished, you should be able to
move the glass slightly, horizontally and vertically.
NOTE
For replacement glass, size, thickness and specifi cations
see "REPLACEMENTS" section.
W415-1013 / C / 11.19.13
!
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
APPLIANCE BEFORE OPERATION.
REMOVED, CRACKED, BROKEN OR SCRATCHED.
DONT'S
• Take ash out immediately. Let it accumulate to a
depth of at least one inch. A good ash layer provides
for a longer lasting and better burning fi re.
• Burn wet wood.
• Close the door too soon or damper down too quickly.
• Burn one large log rather than two or three smaller,
more reasonably sized logs.
• Burn at continually "low setting", if glass door is
constantly blackened. This means the fi rebox
temperature is too low.
WARNING
87.1B
56.2