Venting Configuration For Wood/Oil Combination Furnace - Napoleon HYBRID 150 Installation And Operating Instructions Manual

38
THE USE OF A BAROMETRIC DAMPER ON A WOOD OR WOOD/OIL APPLIANCE CAN HAVE THE
EN
1. DILLUTION AIR ENTERING THROUGH THE BAROMETRIC DAMPER MAY PREMATURELY
COOL EXHAUST PRODUCTS CREATING EXCESS CREOSOTE DEPOSITS INSIDE THE
CHIMNEY LEADING TO A CHIMNEY FIRE HAZARD.
2. IF A CHIMNEY FIRE OCCURS, THE BYPASS DAMPER CAN PULL OPEN UNDER DRAFT
PRESSURE AND FORCE FEED AND INTENSIFY THE FIRE. STAY VIGILANT FOR RAPIDLY
DEPOSITING CREOSOTE WHEN RUNNING A VENT SYSTEM WITH A BAROMETRIC DAMPER.
6.2

VENTING CONFIGURATION FOR WOOD/OIL COMBINATION FURNACE

VENTING CONFIGURATION FOR BRINGING SEPARATE WOOD AND OIL FURNACE FLUES INTO A COMMON VENT
1
2
3
4
5
LEFT HAND RA CONFIGURATION
NOTE
Connection of solid fuel and oil fi red appliances to a common chimney, see Section 5.1.4 of CSA B139-
09 and Section 5.2.7 of CAN/CSA B365-10 for conditions allowing a single chimney for wood and oil.
Common chimney must be approved for use with woodburning appliances (2100°F) (1149°C).
W415-1013 / C / 11.19.13
FOLLOWING CONSEQUENCES:
Legend
(ITEMS 1 THROUGH 11 BY INSTALLER)
6
1. Vent/chimney in accordance with CAN/
CSA-B365-10, CSA B139-09, NFPA211,
7
construction and installation by qualifi ed licensed
installer
8
2. 7" (178mm) T
3. 6" to 7" (152mm to 178mm) Increaser
9
4. 6" (152mm) T
10
5. 6" (152mm) End cap for clean out
6. 5" to 7" (127mm to 178mm) Increaser
7. 90° 5" (127mm) Elbow
8. Barometric damper
9. 45° 5" (127mm) Elbow (change angle to suit
incline)
10. WARNING: Oil fl ue to be mounted on same side
11
of furnace as blower box, to respect clearance to
12
combustible dimensions.
11. 90° 5" (127mm) Elbow (offset in two directions)
12. Heat shield
STRICTLY ADHERE TO ALL IDENTIFIED INSTALLATION CLEARANCES.
H3.78
1
6
2
7
3
8
4
9
5
10
11
12
RIGHT HAND RA CONFIGURATION
H3.55