Convenience Closing Feature - Mercedes-Benz E-Class Coupe Operator's Manual

Side windows
84

Convenience closing feature

Important safety notes
Information on the side window reversing fea-
ture ( page 82).
Y
G
WARNING
When the convenience closing feature is oper-
ating, parts of the body could become trapped
in the closing area of the side window and the
sliding sunroof. There is a risk of injury.
Observe the complete closing procedure
when the convenience closing feature is oper-
ating. Make sure that no body parts are in
close proximity during the closing procedure.
Proceed as follows if someone is trapped:
With the SmartKey:
Release the & button.
X
Press and hold the % button until the side
X
windows and the sliding sunroof or the pano-
rama roof with power tilt/sliding panel open
again.
With KEYLESS-GO:
Release the sensor surface on the door han-
X
dle.
Pull the door handle immediately and hold it.
X
The side windows and the sliding sunroof or
the panorama roof with power tilt/sliding
panel open.
General notes
When you lock the vehicle, you can simultane-
ously:
close the side windows
R
close the panorama roof with power tilt/slid-
R
ing panel
On vehicles with a panorama roof with power
tilt/sliding panel, you can then close the roller
sunblind.
Using the SmartKey
Vehicles without KEYLESS-GO: point the tip
X
of the SmartKey at the door handle on the
driver's door.
Vehicles with KEYLESS-GO: the SmartKey
X
must be in close proximity to the vehicle.
Press and hold the & button until the side
X
windows and the panorama roof with power
tilt/sliding panel are fully closed.
Make sure that all the side windows and the
X
panorama roof with power tilt/sliding panel
are closed.
On vehicles with a panorama roof with power
tilt/sliding panel:
Press and hold the & button again until the
X
roller sunblind of the panorama roof with
power tilt/sliding panel closes.
To interrupt convenience closing: release
X
the & button.
Using KEYLESS-GO
The driver's door and the door at which the han-
dle is used, must both be closed. The SmartKey
must be outside the vehicle. The gap between
the SmartKey and the corresponding door han-
dle should not be greater than 3 ft (1 m).
Touch recessed sensor surface : on the
X
door handle until the side windows and the
panorama roof with power tilt/sliding panel
are fully closed.
i
Make sure you only touch recessed sensor
surface :.
Make sure that all the side windows and the
X
panorama roof with power tilt/sliding panel
are closed.
On vehicles with a panorama roof with power
tilt/sliding panel:
Touch recessed sensor surface : on the
X
door handle again until the roller sunblind of
the panorama roof with power tilt/sliding
panel closes.