Mercedes-Benz E-Class Coupe Operator's Manual page 153

Depending on the specified minimum distance,
your vehicle will come to a standstill at a suffi-
cient distance behind the vehicle in front. The
specified minimum distance is set using the
control on the cruise control lever.
When DISTRONIC PLUS is activated, the trans-
mission is shifted automatically to position P if:
the driver's door is open and the driver's seat
R
belt is unfastened.
the engine is switched off, unless it is auto-
R
matically switched off by the ECO start/stop
function.
a system malfunction occurs.
R
the power supply is not sufficient.
R
Setting a speed
Press the cruise control lever up : for a
X
higher speed or down ; for a lower speed.
To adjust the set speed in 1 mph incre-
X
ments (1 km/h increments): briefly press
the cruise control lever up : or down ; to
the pressure point.
Every time the cruise control lever is pressed
up : or down ;, the last speed stored is
increased or reduced.
To adjust the set speed in 5 mph incre-
X
ments (10 km/h increments): briefly press
the cruise control lever up : or down ; to
the pressure point.
Every time the cruise control lever is pressed
up : or down ;, the last speed stored is
increased or reduced.
i
If you accelerate to overtake, DISTRONIC
PLUS adjusts the vehicle's speed to the last
speed stored after you have finished overtak-
ing.
Driving systems
Setting a specified minimum distance
You can set the specified minimum distance for
DISTRONIC PLUS by varying the time span
between one and two seconds. With this func-
tion, you can set the minimum distance that
DISTRONIC PLUS keeps to the vehicle in front,
dependent on vehicle speed. You can see this
distance in the multifunction display
( page 152).
Y
i
Make sure that you maintain a sufficient
distance to the vehicle in front and comply
with the minimum distance as required by
law. Adjust the distance to the vehicle in front
if necessary.
You can set the specified minimum distance for
DISTRONIC PLUS by varying the time span
between one and two seconds. With this func-
tion, you can set the minimum distance that
DISTRONIC PLUS keeps to the vehicle in front,
dependent on vehicle speed. You can see this
distance in the multifunction display
( page 152).
Y
To increase: turn control ; in direction =.
X
DISTRONIC PLUS then maintains a greater
distance between your vehicle and the vehicle
in front.
To decrease: turn control ; in direction :.
X
DISTRONIC PLUS then maintains a shorter
distance between your vehicle and the vehicle
in front.
151
Z