Assemble Legs; Install Optional Fan - Vermont Castings 0003380 Operating Manual

Assemble the Legs
1. Slide stove to the rear of the pallet just far enough to
access rear leg holes. Make sure the stove does not
tip over backwards. (Fig. 6)
Fig. 6 Slide stove back just far enough to access rear leg
holes.
2. Attach the rear legs using 3/8" hex head bolts and
ST720
flat washer supplied. Tighten with a 9/16" wrench
or socket. Remove and discard the large slot-head
Radiance
screws using the flat-blade screwdriver.
slide stove back
3. Carefully tip the stove onto its rear legs. Adjust the
7/30/02 djt
pallet to allow access to one of the front leg holes.
Be sure to leave the pallet under the stove to prevent
the stove from falling fully forward. (Fig. 7)
CAUTION: To prevent valve tubing from being
crushed or damaged, make sure to rest valve on
wooden pallet.
ST721
Fig. 7 Carefully tip stove onto back legs. Leave pallet under
stove to keep stove from falling fully forward.
ST721
4. Have your assistant attach one leg using the hard-
Radiance
ware described.
attach
5. Move the pallet to allow access to the other front leg
front legs
hole. Attach remaining leg.
7/30/02 djt
30005056
ST720
Washer
Hex Head Bolt
Radiance® Vent-Free Gas Heater
6. Remove pallet and allow stove to gently rest on all
four legs.
7. Adjust leg levelers to compensate for irregularities in
the hearth.

Install Optional Fan

It is easiest to install the optional fan kit #2767/FK26,
before the stove is moved to its final location or con-
nected to the gas line.
The fan consists of a blower assembly and a rheo-
stat switch that are connected by a wire harness. The
blower attaches to a bracket at the bottom of the rear
shroud. The rheostat installs at the bottom of the stove
on the left of the valve.
The fan kit includes a 'snapstat', a temperature-sens-
ing switch which will be mounted to the blower duct just
below the top plate of the stove. The snapstat automati-
cally turns the fan on or off at approximately 109° F.
The rheostat provides a range of fan speed settings
from OFF (which overrides the snapstat function) to
high.
Kit Contents
• Fan assembly with rheostat and snapstat
• wire tie • control knob
CAUTION: Sheet metal edges can be sharp. Be sure to
wear protective gloves.
1. Loosen the four phillips head screws which secure
the rear shroud to the stove sides. (Fig. 8)
2. Carefully pull the shroud assembly away from the
rear of the stove.
3. With the rear shroud assembly in the upright posi-
tion, set the bottom of the shroud on a padded surface
to prevent scratching the surface. Unfasten the four
phillips head screws which attach the outer shroud to
the inner duct assembly.
Rear Shroud As-
sembly
Fig. 8 Loosen four phillips screws holding rear shroud as-
sembly and remove. Remove four phillips screws holding rear
shroud to inner duct assembly. Remove rear shroud.
• retaining collar
ST189
ST189
fan remove shroud
radiance
11/99
9