Vermont Castings 0003380 Operating Manual page 10

Radiance® Vent-Free Gas Heater
4. Attach the fan assembly to the fan bracket provided
in the log box. Use #10 sheet metal screws provided
with fan kit. Do not remove finger guard screws. (Fig. 9)
ST669
Fig. 9 Attach the fan assembly to the fan bracket.
5. Connect snapstat leads. Disconnect the snapstat
module from the leads inside the snapstat bracket. (Fig.
ST669
10) Bend open the snapstat bracket. Use needlenose
RUVSOD
pliers to remove the black plastic grommet from the
attach fan to bracket
bracket. Discard the bracket. Insert the grommet and
7/01
wires into the large hole at the bottom right corner of
the inner shroud. Feed the snapstat wire leads through
the grommet into the stove interior. Connect the two
wires to the two snapstat extension leads attached to
the inner shroud.
Fig. 10 Remove the snapstat and grommet from the bracket
and insert the grommet into the inner shroud.
10
Snapstat
Wire
Rheostat
Wire
Fan
Bracket
Finger Guard
Snapstat Bracket
Snapstat Module
Pinch
Grommet to
Remove
ST640
RUVSOD
snapstat
7/01
6. Position the fan assembly so the ducts slide be-
tween the inner and outer shroud. The inner shroud
should engage with the two slots in the ends of the
bracket so that bracket and shroud are interlocked.
(Fig. 11) Secure the bracket with the four sheet metal
screws provided in the finish bag.
7. Route the rheostat wire assembly to the right be-
tween the inner and outer shroud. Run the wire through
the slots at the bottom right corner of the inner shroud.
8. Refasten the outer shroud to the inner duct assem-
bly.
Outer
Shroud
Fig. 11 Position the fan to engage the inner shroud with the
fan bracket slots and secure with sheet metal screws.
9. Install the snapstat by loosening the front screw on
the inner side of the duct (Fig. 12) slide the snapstat
under the head of the screw and tighten. Connect the
leads to the snapstat. Make sure the snapstat assembly
is mounted straight front to back.
Left Air Duct
Fig. 12 Install the snapstat and connect the extension wire
terminals. View is with top removed, however, access is
available through the rear when installing fan before gas line
connection.
10. Slide shroud assembly over the sides and fasten
the four screws loosened earlier.
11. The rheostat control switch attaches to the left side
of the valve bracket at the front of the stove. (Fig. 13)
•
Remove retaining nut from shaft of rheostat. (if
ST670
pre-installed)
•
Insert the rheostat through the hole in the back
of the left side of the valve bracket, aligning the
locator pin with the smaller hole in that bracket.
Slot
{Inner Shroud}
Slot
ST194
attach fan to shroud
11/99
Snapstat
ST195
attach snapstat
11/99
ST194
ST671
30005056