Ordering Accessories; Removing The Rechargeable Shaver Battery - Philips AT941 User Manual

8 Insert the lug of the shaving unit into the slot in the top of the shaver.
Then close the shaving unit.
Note: If the shaving unit does not close smoothly, check if you have inserted
the shaving heads properly and if the retaining frame is locked.
9 Press and hold the on/off button for 5 seconds to reset the
replacement reminder on the shaver. The orange light will go out.

Ordering accessories

To buy accessories or spare parts, visit www.shop.philips.com/service
or go to your Philips dealer. You can also contact the Philips Consumer
Care Centre in your country (see the worldwide guarantee leaflet for
contact details).
To retain the top performance of your shaver, make sure you clean it
regularly and replace its shaving heads at the recommended time.
Shaving heads
- We advise you to replace your shaving heads every two years. Always
replace with HQ9 (AT941/AT940) or HQ8(AT897/AT896/AT894/
AT891/AT890/AT889/AT887/AT886/AT872/AT811/AT797/AT796/
AT790/AT770/AT756/AT753/AT751/AT750) Philips Shaving Heads.
Cleaning
- Use Cleaning spray (HQ110) to clean the shaving heads thoroughly.
Recycling
Do not throw away the appliance with the normal household waste at the
end of its life, but hand it in at an official collection point for recycling.
By doing this, you help to preserve the environment.

Removing the rechargeable shaver battery

Only remove the rechargeable battery when you discard the shaver.
Make sure the rechargeable battery is completely empty when you
remove it.
1 Undo the screws in the back of the shaver and in the hair chamber.
2 Remove the front panel and the back panel.
ENGLISH
15