Installation Information - Carrier 40MB*D Installation Instructions Manual

If the refrigerant leaks during installation, ventilate the
area immediately.
Toxic gas may be produced if the refrigerant comes into the
place contacting with fire.
The temperature of refrigerant circuit will be high, please
keep the interconnection cable away from the copper
tube.
After completing the installation work, check that the
refrigerant does not leak.
Toxic gas may be produced if the refrigerant leaks into the
room and comes into contact with a source of fire, such as a
fan heater, stove or cooker.
The appliance shall be installed in accordance with
national wiring regulations.
Do not operate your air conditioner in a wet room such
as a bathroom or laundry room.
An all-pole disconnection device which has at least 3mm
clearances in all poles , and has a leakage current that
may exceed 10mA, the residual current device (RCD) has
a rated residual operating current not exceeding 30mA,
and disconnection must be incorporated in the fixed
wiring in accordance with the wiring rules.
CAUTION
Ground the air conditioner.
Do not connect the ground wire to gas or water pipes,
lightning rod or a telephone ground wire. Inappropriate
grounding may result in electric shocks.
Be sure to install an earth leakage breaker.
Failure to install an earth leakage breaker may result in
electric shocks.
Connect the outdoor unit wires, then connect the indoor
unit wires.
You are not allowed to connect the air conditioner with the
power supply until the wiring and piping is done.
While following the instructions in this installation
manual, install drain piping in order to ensure proper
drainage and insulate piping in order to prevent
condensation.
Improper drain piping may result in water leakage and
property damage.
Install the indoor and outdoor units, power supply wiring
and connecting wires should be at least 3.28ft/1m away
from televisions or radios in order to prevent image
interference or noise.
Depending on the radio waves, a distance of 3.28ft/1m may
not be sufficient enough to eliminate the noise.
The appliance is not intended for use by young children
or infirm persons without supervision.
Don't install the air conditioner in the following
circumstance:
•
There is petroleum nearby.
• There is salty air nearby (near the coast).
• There is caustic gas (sulfide, for example)
in the air (near a hot spring).
The volt vibrates violently (in the factories).
In buses or cabinets.
In kitchen where it is full of oil gas.
There is strong electromagnetic wave.
There are inflammable materials or gas.
There is acid or alkaline liquid evaporating.
Other special conditions.
2. INSTALLATION INFORMATION
•
To install properly, please read this installation manual at
first.
• The air conditioner must be installed by qualified persons.
• When installing the indoor unit or its tubing, please follow
this manual closely.
• If the air conditioner is installed on a metal part of the
building, it must be electrically insulated according to the
relevant standards to electrical appliances.
•
When all the installation work is finished, please turn on
the power only after a thorough check.
INSTALLATION ORDER
•
Select the location.
•
Install the indoor unit.
• Install the outdoor unit.
• Install the connecting pipe.
• Connect the drain pipe.
• Wiring.
• Test operation.
5