G E T T I N G S T A R T E D
• After pushing the Keyless Enter-N-Go LOCK button, you must wait two seconds before
you can lock or unlock the vehicle using the door handle. This is done to allow you to
check if the vehicle is locked by pulling the door handle without the vehicle reacting
and unlocking.
• If a Keyless Enter-N-Go door handle has not been used for 72 hours, the Keyless
Enter-N-Go feature for that handle may time out. Pulling the deactivated front door
handle will reactivate the door handle's Keyless Enter-N-Go feature.
To Enter The Trunk
• With a valid Keyless Enter-N-Go Key Fob
located outside the vehicle and within 5
ft (1.5 m) of the deck lid, push the
button located on the center of the light
bar which is located on the deck lid
above the license plate.
NOTE:
Refer to your Owner's Manual on the DVD
for further information.
ENGINE STARTING/STOPPING
Accessory Positions With Engine Off
NOTE:
The following functions are with the driver's foot OFF the Brake Pedal/Clutch Pedal
(Transmission in PARK or NEUTRAL Position).
Starting With The Ignition Switch In The
OFF Position:
• Push the ENGINE START/STOP button
once to change the ignition switch to the
ACC position.
• Push the ENGINE START/STOP button a
second time to change the ignition switch to the RUN position.
• Push the ENGINE START/STOP button a third time to return the ignition switch to the
OFF position.
18
Trunk Release Button
Accessory Positions