Dodge challenger 2016 User Manual page 21

Engine Starting/Stopping — Automatic Transmission
Starting
• Place the shift lever in PARK or NEU-
TRAL.
• Press and hold the brake pedal, then
push the ENGINE START/STOP button
once. If the engine fails to start, the
starter will disengage automatically after
10 seconds.
• To stop the cranking of the engine prior
to the engine starting, push the button
again.
Stopping
• Place the shift lever in PARK.
• Push the ENGINE START/STOP button once. The ignition switch will return to the OFF
position.
• If the shift lever is not in PARK, the ENGINE START/STOP button must be held for two
seconds and vehicle speed must be above 5 mph (8 km/h) before the engine will shut
off.
NOTE:
If the ignition switch is left in the ACC or RUN (engine not running) position and the
transmission is in PARK, the system will automatically time out after 30 minutes of
inactivity and the ignition will switch to the OFF position.
Engine Starting/Stopping — Manual Transmission
Starting
• Push and hold the clutch pedal while pushing and holding the ENGINE START/STOP
button. Release the button when the engine starts. If the engine fails to start within 15
seconds, release the button, wait 10 to 15 seconds, then repeat.
• To stop the cranking of the engine prior to the engine starting, release the button.
G E T T I N G S T A R T E D
1 – Start/Stop Button
19