Vehicle Security Alarm - Dodge challenger 2016 User Manual

G E T T I N G S T A R T E D
Stopping
• With the vehicle stopped, place the shift lever in NEUTRAL.
• Push the ENGINE START/STOP button once. The ignition switch will return to the OFF
position.
• If the vehicle speed is above 5 mph (8 km/h), the ENGINE START/STOP button must be
held for two seconds before the engine will shut off. The ignition switch position will
remain in the ACC position until the vehicle is stopped and the button is pushed twice
to the OFF position.
NOTE:
If the ignition switch is left in the ACC position, the system will automatically time out
after 60 minutes of inactivity and the ignition will switch to the OFF position.

VEHICLE SECURITY ALARM

The Vehicle Security Alarm monitors the vehicle doors for unauthorized entry and the
ignition for unauthorized operation. While the Vehicle Security Alarm is armed, interior
switches for door locks and decklid release are disabled. If something triggers the alarm,
the Vehicle Security Alarm will provide the following audible and visible signals: the horn
will pulse, the park lamps and/or turn signals will flash, and the Vehicle Security Light in
the instrument cluster will flash.
To Arm
• Keyless Enter-N-Go button installed: Push the Keyless Enter-N-Go START/STOP button
until the Driver Information Display (DID) indicates that the vehicle ignition is "OFF."
Push the power door LOCK switch while the door is open, Push the Key Fob LOCK
button, or with one of the Key Fobs located outside the vehicle. and within 5 ft (1.5 m)
of the driver's and passenger front door handles, push the Keyless Enter-N-Go LOCK
button located on the door handle.
• Keyless Enter-N-Go button not installed: Turn the ignition switch to the "OFF" position.
Push the power door lock switch while the door is open, push the Key Fob LOCK button
with one of the Key Fobs located outside the vehicle and within 5 ft (1.5 m) of the
driver's and passenger front door handles.
NOTE:
After pushing the Keyless Enter-N-Go LOCK button, you must wait two seconds before you
can lock or unlock the vehicle via the door handle.
To Disarm
• Keyless Enter-N-Go button installed: Push the Key Fob UNLOCK button or with one of
the Key Fobs located outside the vehicle and within 5 ft (1.5 m) of the driver's and
passenger front door handles, grab the Keyless Enter-N-Go door handle and enter the
vehicle, then push the Keyless Enter-N-Go START/STOP button (requires at least one
valid Key Fob in the vehicle).
20