Engine Starting/Stopping - Dodge Charger 2016 User Manual

• After pushing the Keyless Enter-N-Go LOCK button, you must wait two seconds before
you can lock or unlock the vehicle using the door handle. This is done to allow you to
check if the vehicle is locked by pulling the door handle without the vehicle reacting
and unlocking.
• If a Keyless Enter-N-Go door handle has not been used for 72 hours, the Keyless
Enter-N-Go feature for that handle may time out. Pulling the deactivated front door
handle will reactivate the door handle's Keyless Enter-N-Go feature.
To Enter The Trunk
• With a valid Keyless Enter-N-Go Key Fob
located outside the vehicle and within 5
ft (1.5 m) of the deck lid, push the
button on the right side of applique
which is located on the deck lid.
• Whenever the vehicle is unlocked, you
can enter the trunk by pushing the but-
ton on the right side of the applique.
NOTE:
Please refer to "Keyless Enter-N-Go" in
"Things To Know Before Starting" in your
Owner's Manual on the DVD for further
information.

ENGINE STARTING/STOPPING

Starting
• Place the shift lever in PARK or NEU-
TRAL.
• While pushing the brake pedal, push the
ENGINE START/STOP button once. If
the engine fails to start, the starter will
disengage automatically after 10 sec-
onds.
• To stop the cranking of the engine prior
to the engine starting, push the button
again.
G E T T I N G S T A R T E D
Trunk Passive Entry Button
Engine START/STOP Button
17