Slit Glass Cleaning Pad - Toshiba e-STUDIO2330C Service Manual

(4) Disconnect 1 connector, release the latch
and take off the shutter status detection
sensor.
Note:
If the gears (front/rear) of the shutter unit
have been removed, be sure to align the
mark on the gears with the one on each side
of the rack respectively when reassembling
them.
9.4.5

Slit glass cleaning pad

(1) Open the front door. Then take off the slit
glass cleaner.
(2) Press 2 latches to the inner side, and then
remove the slit glass cleaning pad.
9.4.6 Polygonal motor
Note:
Polygonal motor replacement is not recommended in the field; the image quality is not
guaranteed in such a case.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Fig. 9-30
Slit glass cleaning pad
Fig. 9-31
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
9 - 17
Shutter status
detection sensor
Gear
Rack
LASER OPTICAL UNIT
9