Configure The Realpresence Group System; Setup Wizard - Polycom realpresence group series Administrator's Manual

EagleEye Director indicator light
This indicator light provides the following information.
Indicator Light
Steady green light
Steady red light
Blinking red light
Blinking blue light

Configure the RealPresence Group System

This section describes how to configure your RealPresence Group system by using the setup wizard that
walks you through the initial steps. It also explains how to access administrative settings in the local and
web interfaces.

Setup Wizard

When you power on your system for the first time, the setup wizard leads you through the minimum
configuration steps required to place a call.
The setup wizard allows you to set an Admin ID and password, which allows you to limit access to the Admin
Settings. The default Admin ID is admin and the default admin password is the 14-digit system serial
number on the Settings > System Information > Information > System Detail screen in the local interface
or on the back of the system. Admin and User IDs are not case sensitive.
Note: Remember admin password
Make sure you can recall the admin password if you set one. If you forget the password, you must use
the restore button to run the setup wizard again in order to access the Admin Settings and reset the
password.
You can run the setup wizard or view the configuration screens in either of the following two ways.
● In the room with the system—You can navigate the screens and enter information by using the
remote control and the onscreen keyboard. When you reach a text field, press the Select button on
the remote control to display the onscreen keyboard. Note that the onscreen keyboard is
automatically displayed when you reach the System Name field in the setup wizard.
Be aware that only those configuration screens needed to get the system connected are included in
the local interface. Most of the administrative settings are available only in the web interface.
Polycom, Inc.
Introducing the Polycom RealPresence Group Series Systems
Status
Cameras are ready; camera tracking is off
Cameras are powering on
Factory restore on the cameras is starting
Camera tracking is on
28