Top Burner Removal; Top Burner Ignitor Removal; Spark Module Removal - Viking VGR30 Service Manual

TOP BURNER REMOVAL

1. Shut off power to the oven.
2. Remove grates, burner bowls and grate supports.
3. Remove the phillip head screw near the burner
head securing the burner to the burner support.
4. Lift the burner and venturi assembly and remove
the wire from the bottom of the ignitor.
5. Both burner assemblies (front and read) can be
removed together by removing one (1) screw at the
rear of the burner support, remove both ignitor
wires and lift the burner support assembly.

TOP BURNER IGNITOR REMOVAL

1. Shut off power to the oven.
2. Remove grate and burner bowl.
3. Remove two (2) screws securing the ignitor to the
burner support.
4. Disconnect the ignitor wire.

SPARK MODULE REMOVAL

NOTE: FOUR BURNER MODELS WITH OR
WITHOUT A GRIDDLE USE ONLY ONE
(1) SPARK MODULE; FOUR (4)
BURNERS WITH A CHAR GRILL
REQUIRES TWO (2) SPARK MODULES.
1. Remove left and right grates, burner bowls and
grate supports.
2. Remove two (2) screws securing the spark module
cover, using care not to damage wiring.
3. Disconnect the wiring. (When replacing module
cover, do not forget to ground green wire to
chassis.)
4. For wiring sequence see wiring schematic section.
BURNER BOX SECTION
26