Volvo XC90 Owner's Manual page 178

WARNING
Never position anything between the
ground and the jack, nor between the jack-
ing point and the jack.
WARNING
If the jack is positioned incorrectly, the car
could fall. Risk of injury.
5. Place the jack under the jacking point and
crank it up towards the car floor. There is
an recess in the plastic cover at each
anchorage point. Check that the jack sits
securely in the anchorage. Then adjust the
jack so that its foot is positioned vertically
under the anchorage. See illustration.
6. Lift the car until the wheel is free.
7. Remove the wheel bolts and lift off the
wheel.
Fitting the wheel
1. Clean the contract surfaces on the wheel
and hub.
2. Put on the wheel. Screw in the wheel bolts.
3. Lower the car so that the wheel cannot
rotate.
4. Tighten the wheel bolts alternately and in
torque steps. Tightening torque: 140 Nm
(14.0 kpm). It is important that they are
tightened to the correct torque. Check with
a torque wrench.
5. Screw the jack all the way down before
returning it to the cargo area. Then secure
it in place.
6. Check that the new tyre has the correct
amount of pressure.
NOTE
This wheel bolt may also be used for steel
wheel rims.
Make sure to use the correct type of bolt. If you
are unsure, check with the nearest Volvo work-
shop.
IMPORTANT
If TPMS is specified then the tyres must be
calibrated after fitting, see page 178
07 Wheels and tyres
Changing wheels
07
177