Oven Door Latch; Door Plunger Light Switch Assembly; Oven Light Bulb/Oven Light Socket; Oven Door Removal - Jenn-Air JGW8130DD series Service Manual

Disassembly Procedures
!

Oven Door Latch

1. Remove control panel assembly, see "Control Panel
Assembly" procedure steps 1 through 3.
2. Remove screws securing latch assembly to the front
of oven cavity.
3. Remove screws securing latch assembly to the top of
oven chassis.
4. Remove latch assembly from chassis.
5. Disconnect and label wire terminals.
6. Reverse procedure to reassemble door latch
assembly.

Door Plunger Light Switch Assembly

NOTE: Requires removal of unit from cutout opening.
1. Turn off power to the unit at the circuit breaker.
2. Remove oven door, see "Door Removal" procedure.
3. Remove screws securing wall oven to cabinet.
4. Remove unit from cutout position and place on a
protective surface.
5. Remove screws securing back cover to chassis and
remove.
6. Remove screws securing top cover to chassis and
remove.
7. Remove screws securing right side body panel to
chassis and remove.
8. Remove screw securing switch to plunger assembly.
9. Reverse procedure to reinstall oven door hinge
assembly.
Oven Light Bulb / Oven Light Socket
1. Turn off power to the unit at the circuit breaker.
2. Open oven door or remove oven door to gain access to
oven light.
3. Slide bulb cover retainer to the side to release bulb
cover and remove bulb cover.
4. Using a glove, unscrew (counterclockwise) oven light
bulb.
NOTE: Proceed with the following steps for oven light
socket removal.
5. Remove screws securing oven light socket to the rear
of oven cavity wall.
6. Pull oven light socket into the oven cavity.
7. Disconnect wires from light socket.
8. Reverse procedure to reinstall light socket.
22
WARNING
16022514 Rev. 0
To avoid risk of electrical shock, personal injury, or death,
disconnect electrical power and shut-off gas supply to
unit before servicing.

Oven Door Removal

1. Open oven door.
2. Place oven door in first stop position, then grasp both
sides and lift up off the hinges.
NOTE: Door hinges are spring loaded and will snap
closed if bumped. Avoid pinching fingers by
closing hinges completely until ready to mount
door back on the unit.
3. Reverse procedure to reassemble.

Frameless Door Disassembly

1. Remove oven door, see "Door Removal".
2. Remove screws on right, left, top, and bottom of oven
door.
3. Remove door liner from door assembly.
4. Remove screws securing inner glass support securing
glass and door handle.
5. Remove glass mounting bracket and glass window.
6. Remove screws securing heat door liner shield and
remove.
7. Reverse procedure to reassemble.
NOTE: When reassembling door, verify HB II marking on
the glass is facing towards the heat (inside of the
oven).
© 2004 Maytag Services