Jenn-Air JGW8130DD series Service Manual page 34

Installation Instructions
*DV &RQYHUVLRQ
`…‚€ˆ†‹„ j~‹†ƒŒ‰ d~ m‚’‚
_rfiqJfk lsbkpW
On built-in ovens, remove 1/8 inch pipe plug from side of
gas pressure regulator, install 1/8² "B" valve, 1/8 inch
piece of pipe, connect manometer, make sure main
burner is on to obtain accurate pressure check.
Be sure the gas supply (house piping) pressure is at least
one inch (1²) above specified range manifold pressure.
The gas supply pressure should never be over fourteen
inches (14²) water column.
A–8
`…‚€ˆ†‹„ m‚’‚ lƒ eŒ’‚ m††‹„ p–‘‚Š
The appliance and its individual shutoff valve must be
disconnected from the gas supply piping system during
any pressure testing of that system at test pressures in
excess of 1/2 lbs./sq. in. (14 in. W.C.).
The appliance must be isolated from the gas supply
piping system by closing its individual manual shutoff
valve during any pressure testing of the gas supply piping
system at test pressures equal to or less than 1/2 lbs./sq.
in. (14 in. W.C.).
b•‰Œ‚ _Œ‘‘ŒŠ _’‹‚ ^‚Š‰–
16022514 Rev. 0
© 2004 Maytag Services