Jenn-Air JGW8130DD series Service Manual page 14

Troubleshooting Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect power to oven before servicing, unless
testing requires power.
Problem
Oven light does not operate.
Self-clean cycle not working
Oven door will not unlock
Oven smokes/odor first few
times of usage
Failure Codes
14
!
W ARNING
Possible Cause
Failed oven lamp .........................................
Failed wiring ................................................
Failed light socket........................................
Failed light plunger ......................................
Programming error ......................................
Oven is self-cleaning ...................................
Oven is still hot ............................................
Normal .........................................................
Electronically Controlled..............................
16022514 Rev. 0
Correction
• Check lamp and replace is
necessary.
• Check for broken, loose or dirty
connections.
• Check light socket for continuity.
• Check plunger for continuity.
• Shut off power to oven for five
minutes by switching off circuit
breaker. Reset circuit breaker
and try oven again.
• Allow cycle to complete.
• Will not unlock until unit has
cooled to safe temperature. Do
not force door open, this will void
warranty. Blow cool air on door
latch area to quicken process.
• Minor smoking or odor is normal
the first few times of oven usage.
• Ventilate area well and perform
self-clean cycle.
• Refer to specific Technical Sheet
for diagnostic checks.
© 2004 Maytag Services