Jenn-Air JGW8130DD series Service Manual page 33

Installation Instructions
*DV &RQYHUVLRQ
d‚‹‚~‰
All ovens are equipped with interchangeable orifices for
natural gas and for LP/Propane. To convert the unit will
require changing of the orifice plug and hood plus an
adjustment to the air shutter on the burners and to the
pressure regulator.
Inlet pressure to the appliance pressure regulator should
be as follows for both operation and checking of
appliance pressure regulator setting:
fkibq mobpprob fk
fk`ebp lc t^qbo
Minimum
Maximum
^‰†~‹€‚ m‚’‚ o‚„’‰~‘Œ `Œ‹“‚†Œ‹
The ovens appliance pressure regulator must be set to
match the type of gas supply used. If converting from
natural gas to LP gas, the appliance pressure regulator
must be converted to regulate LP gas. If converting from
LP gas to natural gas, the appliance pressure regulator
must be converted to regulate natural gas. The type of
gas for which the regulator is set for will be visible on the
plastic plunger which is snapped on to the bottom of the
brass hex nut (either Nat. or LP).
WHEN THE INSTALLER HAS COMPLETED
INSTALLATION OF APPLIANCE, LEAVE THE
APPLIANCE PRESSURE REGULATOR
SHUT-OFF VALVE IN THE
TURN COUNTERCLOCKWISE
© 2004 Maytag Services
k^qro^i
d^p d^p
5
14
¥lk³
POSITION.
(SHOWN IN OFF POSITION)
TO ¥lk³ POSITION.
TO CONVERT THE APPLIANCE PRESSURE
REGULATOR FOR USE WITH LP GAS. (The wall oven
is shipped from the factory adjusted for use with natural
gas.):
1. Unscrew the brass hex nut from the regulator from the
neck of the regulator. (A wrench may be required.)
2. Unsnap the plastic pin or plunger locate inside the hex
im
nut by applying a sideward pressure to the pin.
11
3. Invert the pin and snap it back into place within the cap
14
applying even finger pressure at the opposing edges of
the pin's circular disc. The pin must be seated firmly
and squarely in the cap. (See figure 3.)
Pin replacement is most easily accomplished by
placing the cap on a flat horizontal surface and
applying downward finger pressure at the edges of the
pin's disc.
4. Screw the hex nut securely back into place in the neck
of the pressure regulator. (The hex nut should be
finger tightened to secure it in place.)
cfdrob P
16022514 Rev. 0 A–7