Disassembly Procedures; Removing And Replacing Oven; Control Panel Assembly; Control Board - Jenn-Air JGW8130DD series Service Manual

Disassembly Procedures

!
!
CAUTION
To avoid risk of personal injury or property damage this
unit requires a two man lift when lifting unit in or out of
cutout.

Removing and Replacing Oven

1. Turn off power to the unit at the circuit breaker.
2. Open oven door and remove screws securing unit to
the wall.
3. Pull oven forward out of the cabinet opening.
4. Unplug the power cord leading from unit to outlet.
5. Disconnect gas supply from unit.
6. Replace the oven using the Installation Instructions.
After final gas connection is made, turn on manual gas
valve and test all connections in gas supply piping and
oven for gas leaks.
!
WARNING
To avoid property damage or serious personal injury,
never use a lighted match to test for gas leaks.

Control Panel Assembly

1. Turn off power to the unit at the circuit breaker.
2. Remove screws securing bottom portion of top trim
vent piece to side trim.
3. Rotate bottom portion of top trim vent piece upward to
gain access to control panel.
4. Disconnect and label terminal connector plugs from

control board.

!
CAUTION
While unplugging electrical connections, pins may be
damaged, use extreme care when disconnecting.
5. Gently pull control panel upward to remove complete
assembly.
6. Reverse procedure to reassemble control panel.
© 2004 Maytag Services
WARNING
16022514 Rev. 0
To avoid risk of electrical shock, personal injury, or death,
disconnect electrical power and shut-off gas supply to
unit before servicing.
Control Board
1. Remove control panel assembly, see "Control Panel
Assembly" procedure steps 1 through 4.
2. Disconnect ribbon cable from control board.
3. Remove screws securing control board bracket to

control panel.

4. Gently remove control board and bracket from unit.
5. Reverse procedure to reassemble.
Control Panel
1. Remove control panel assembly, see "Control Panel
Assembly" procedure steps 1 through 4.
2. Disconnect ribbon cable from control board.
3. Remove screws securing control board bracket to
control panel.
4. Gently remove control board and bracket from unit.
5. Reverse procedure to reassemble.
Temperature Hi- Limit Switch
1. Remove control panel assembly, see "Control Panel
Assembly" procedure steps 1 through 3.
2. Disconnect wire terminals from limit switch.
3. Remove screws securing control limit switch.
4. Reverse procedure to reassemble.

Oven Sensor

1. Turn off power to unit.
2. Open oven door or remove oven door, see "Door
Removal".
3. Remove screws securing sensor to top left rear corner
of oven cavity.
4. Pull sensor forward, maneuver wires through insulation
to disconnect wire plug connector.
5. Reverse procedure to reassemble sensor.
21