Table of Contents
Advertisement
Installation Instructions
&RQQHFWLQJ WKH 2YHQ
b‰‚€‘†€ p’‰–
The appliance, when installed, must be electrically
grounded in accordance with local codes or, in the
absence of local codes, with the National Electrical Code,
ANSI/NFPA 70.
In Canada the oven must be installed in accordance with
the current CSA Standard C22.1 - Canadian Electrical
Code Part 1.
bib`qof`^i prmmiv `lkkb`qflkW
The oven requires 120 volts, 60 cycle alternating current
from an outlet capable of supplying 15 amperes.
t^okfkd
b‰‚€‘†€~‰ dŒ’‹†‹„ f‹‘’€‘†Œ‹
This appliance is equipped with a (three-prong) ground-
ing plug for your protection against shock hazard and
should be plugged directly into a properly grounded
receptacle. Do not cut or remove the grounding prong
from this plug.
t^okfkd
afp`lkkb`q bib`qof`^i prmmiv _bJ
clob pbosf`fkd qeb ^mmif^k`bK
d~ p’‰–
a. ^ d^p `rqlcc s^isb pelria _b mrq fk ^k
^``bppf_ib il`^qflk fk qeb prmmiv ifkb
^eb^a lc qeb rkfqI clo qrokfkd lk ^ka
qrokfkd lcc d^p prmmiv. If the unit is to be
connected to house piping with flexible or semi-rigid
metal connectors for gas appliances, CONNECTOR
NUTS MUST NOT BE CONNECTED DIRECTLY TO
PIPE THREADS. THE CONNECTOR MUST BE
INSTALLED WITH ADAPTORS PROVIDED WITH
THE CONNECTOR.
b. The house piping and/or oven connector used to
connect the oven to the main gas supply must be
clean, free of metal shavings, rust, dirt and liquids (oil
or water). Dirt, etc. in the supply lines can cause
failure of the gas valves or controls and clog burners.
`^rqflkW al klq ifcq lo jlsb qeb t^ii
lsbk _v qeb allo e^kaibpK
c.Turn off all pilots and main gas valve of other gas
appliances.
d.Turn off main gas valve at meter.
e. Before connecting the unit, apply pipe thread
compound approved for LPG to all threads.
f. Connect unit to gas supply.
© 2004 Maytag Services
g. Turn on main gas valve at meter, and relight pilots at
other gas appliances.
h. Apply a non-corrosive leak detection fluid to all joints
and fittings in the gas connection between the supply
line shut-off valve and the range. Include gas fittings
and joints in the range if connections were disturbed
during installation. Check for leaks! bubbles appearing
around fittings and connections will indicate a leak. If a
leak appears, turn off supply line gas shut-off valve,
tighten connections, turn on the supply line gas shut
off valve, and retest for leaks. Never test for gas leaks
with an open flame.
`^rqflkW kbsbo `eb`h clo ib^hp tfqe ^
ci^jbK
tebk ib^h `eb`h fp `ljmibqbI tfmb lcc
^ii obpfarbK
_bclob ifdeqfkd ^kv _rokboI pbb qe^q ^ii
m^`hfkd j^qbof^ip e^sb _bbk objlsba
colj qeb rkfqpK
i. Adjust burner air shutter to the widest opening that will
not cause the flame to lift or blow off the burner when
cold, refer to Unit Adjustments.
Installation of this oven must conform with local codes or,
in the absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1-latest edition.
In Canada the oven must be installed in accordance with
the current CGA Standard CAN/CGA-B149 - Installation
Codes for Gas Burning Appliances and Equipment and/or
local codes.
d^p prmmiv `lkkb`qflkW
^ qo^fkba pbosf`bj^k lo d^p ^mmif^k`b
fkpq^iibo jrpq j^hb qeb d^p prmmiv
`lkkb`qflkK i‚~ˆ ‘‚‘†‹„ Œƒ ‘…‚ ~‰†~‹€‚ …~‰‰ ‚
€Œ‹’€‘‚ – ‘…‚ †‹‘~‰‰‚ ~€€Œ†‹„ ‘Œ ‘…‚
†‹‘’€‘†Œ‹ „†“‚‹ †‹ ‚€‘†Œ‹ …K
NATURAL GAS SUPPLY LINE MUST HAVE A
NATURAL GAS SERVICE REGULATOR. INLET
PRESSURE TO THIS APPLIANCE SHOULD BE
REDUCED TO A MAXIMUM OF 14 INCHES WATER
COLUMN (0.5 POUNDS PER SQUARE INCH (P.S.I.)
LIQUEFIED PETROLEUM (L.P.)
SUPPLY LINE MUST HAVE A L.P. GAS PRESSURE
REGULATOR. INLET PRESSURE TO THIS APPLIANCE
SHOULD BE REDUCED TO A MAXIMUM OF 14
INCHES WATER COLUMN (0.5 P.S.I.). INLET
PRESSURES IN EXCESS OF 0.5 P.S.I. CAN DAMAGE
THE APPLIANCE PRESSURE REGULATOR AND
OTHER GAS COMPONENTS IN THIS APPLIANCE AND
CAN RESULT IN A GAS LEAK.
16022514 Rev. 0
/
PROPANE GAS
A–5
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
