Fiat Brava Service Manual page 443

Electrical equipment
Alarm
Bravo-Brava
55.
o
w
— * < —
r^
x 6 = OK
x 18 = NOT OK
11. Still keeping the receiver button pressed,
the operator should hold the new remote
control about 40 cm away; then they
should press and release the remote con­
trol button.
The LED in the courtesy light should
come on constantly signalling that the
code has been programmed.
12. Release the button: the LED in the cour­
tesy light should GO OFF.
At the end of the procedure if the LED:
- FLASHES 6 times then the code has been
correctly programmed;
- FLASHES 18 times, then this means that
the serial line between the receiver and the
alarm is broken.
After having entered the new remote control code the memory becomes closed again automat­
ically. In order to enter a new remote control repeat the procedure from point 1.
148
ft I -96 - Cancels and replaces
Print no. 506.670/06