Bravo-Brava
Electrical equipment
Radio equipment
FM
1 F't f r
CT F~<
ZJ
55.
Manual station programming
The station to which you are listening can be
programmed in the range selected using but
tons (1), (2), (3), (4), (5) and (6).
Keep the button pressed with which you
wish to programme the station until transmit
ter is audible again. The LED under the
switch will come on and the number corre
sponding to the switch will appear on the
display.
Even if the supply voltage is interrupted, the
memories remin active.
Listening to stations programmed
Proceed as follows:
- Select the band desired using switchs (11), (12) and (13) (see page 50/7);
- pressone of the six station programming buttons briefly;
The LED under the switch will come on and the number corresponding to that switch will appear on the
display. For bands RDS1 and RDS2, if the reception is not gooe, an alternative frequency is automati
cally searched for (the word "SRC" will appear on the display during the search).
TP Function (Traffic Programme)
Several stations belonging to the RDS1, RDS2 bands also transmit information on traffic conditions.
With the TP function (Traffic Programme) it is possible:
a) to search only for RDS stations which transmit traffic information;
b) to receive traffic information even if the cassette player or CD player function is selected;
c) to receive traffic information at a minimum pre-set volume even with the radio volume at zero.
%£s0^>
RDS
=
NOTE
There follows instructions for carry
ing out each of the operations illus
trated for points a), b) and c) de
scribed previously.
Point a)
- Select an RDS1, RDS2 band by pressing
the "RDS" switch (13) briefly (the LED un
der the switch will come on);
- press the "TP" switch (10) briefly so that
the word "TP" appears on the display (the
LED under the switch will come on).
If the transmitter is not enabled to supply
traffic information, then the radio will auto
matically tune into the closest one able to
transmit it.
Copyright by Fiat Auto
50/9