Protected Programming-Manual Closing Of The Memory; Entering The Password - Fiat Brava Service Manual

Bravo-Brava
Electrical equipment
Alarm
55.
PROGRAMMING FURTHER REMOTE CONTROLS USING THE SIMPLIFIED PROCEDURE
In order to programme further remote controls, repeat the procedure for the simplified programming.
It is possible to programme an unlimited number of remote controls, but the courtesy light will only keep
the last eight in its memory.
This procedure is valid until the following conditions occur:
a) the central locking/alarm system has been switched on/switched off correctly via the remote control
256 times;
b) the password for one of the remote controls already programmed has been entere (see paragraph on
MANUAL ACCESS PROGRAMMING).
-r.— The simplified programming procedure definitvely cancels the universal codes present in the
*/£MK
courtesy light and alarm control unit.
Protected programming-manual closing of the memory
In order to prevent strangers from being able to enter their code it is necessary to protect (close) the
memory. This operation takes place:
a) automatically after the alarm system has been switched on/switched off 256 times;
b) if the user so desires by entering the password (4 figure code on the transmitter card) before the
alarm has been switched on/off 256 times, for example on a new vehicle after all the remote control
codes given to the Customer have been introduced.
Entering the password
- The method for entering the password (see
lower inset) is as follows:
1. Press the button on the receiver for
around 2 seconds: the LED should flash.
2. Release the button: after around 2 sec­
onds the LED should flash briefly indicat­
ing that it is possible to enter the first fig­
ure of the password.
Copyright by Fiat Auto
I)I-96 - Cancels and replaces
141