Operating Instructions; Control Panel Overview - EdgeStar AP16000G Owner's Manual

Water Full
Indicator
Signal Receiver
On/Off Button
/ Button
Mode Button
Fan Speed
Water Full
Louvers can
adjust air flow
up or down.
Edgestar Portable Air Conditioner

Operating Instructions

Control Panel Overview

Cool Indicator
Press the button once to manually turn the unit on. Press
once more to turn the unit off.
In COOL, press the
increase the temperature by 1° degree Fahrenheit.
Continue to press to get to desired temperature.
Press the MODE button to cycle between modes: COOL 
DRY  FAN.
COOL: Cool indicator light is bright. Display will show set
temperature (61
DRY: Dehumidify indicator is bright. Display will be blank.
FAN: Fan indicator light is bright. Display will be blank.
Remember that the exhaust hose and window kit must be
installed when the unit is in Cool or Dry Mode.
When the unit is running in Cool or Fan mode, press the
arrow buttons to select the fan speed desired. There are 4
fan settings, High, Middle, Low, and Auto.
When Cool or Dry is running condensation will drain to the
water reservoir. When the water tank is full a buzzer will
sound eight times indicating to empty. An error code "H8"
will also display on LED screen. Please follow instructions
on how to drain on page 9.
Note: This unit has 2-Way directional
louvers (up and down). Once the unit is
powered on the louvers will open to allow
air flow. The remote will allow you to
adjust the louver setting during use.
Once the unit is powered off the louvers
will close.
Display
Fan Indicator
or button to decrease or
◦ ◦
– 86
F).
Dry Indicator
10