Power Connector Cable - HP Pavilion dv7 Maintenance And Service Manual

1. Release the cable from the clips (1) built into the base enclosure.
2. Remove the RJ-11 jack (2) from the clip built into the base enclosure.
3. Remove the assembly from the base enclosure (3).
Reverse this procedure to install the modem module cable.

Power connector cable

Description
Power connector cable
NOTE: The power connector cable is available in the Cable Kit, spare part number 501891-001.
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Optical drive (see
c. Switch cover and keyboard (see
d. Speaker assembly (see
e. Display assembly (see
f. Top cover (see
88 Chapter 4 Removal and replacement procedures
Downloaded from LpManual.com Manuals
Battery on page 43).
Hard drive on page 48).
Optical drive on page
Switch cover and keyboard on page
Speaker assembly on page
Display assembly on page
Top cover on page 74).
Spare part number
536857-001
44).
62).
64).
57).