Renewal Of Water; Softener Regeneration; Stopping The Machine - Rancilio epoca Use And Maintenance

11.3.1. Renewal of water in the boiler
(Fig.12)
Turn off the machine and wait for the pressure in
the boiler to diminish (gauge needl on "0").
Remove the cup-holder grid.
11.3.2. Regeneration
Softener DP2 - DP4
Regenerate the water softener within the time-limi-
ts specified for the softener as follows:
DP2
nr.2 regenerations per month (once a fortnight) for
DP4
nr.2 regenerations per month (once a fortnight) for
This table has been drawn up according to a water
hardness of 25 degress calculated on the French
scale.
See the documentation included with the softener
for the instructions for use.
Model S1 TANK (Fig.13)
Operation to be carried out when the machi-
ne is off and cold and with the plug discon-
nected.
To be effected after the consumption of approx.15
litres of water (average hardness calculated as 35
degress on the French scale) or at least once a
month.
Prepare a solution in a glass of water adding three
dissolved).
Drain the water-tank, see point 10.2.
Slide the softener 1 (Fig.13) off the rubber tubing
2 and turn it over.
Wait about 5 minutes, then hold the softener un-
der a tap and rinse it with water. When the water
for use once again.
60
Put the softener back on the rubber tube and
On completion of this operation, the machine can
described in paragraph 7.3.

12. STOPPING THE MACHINE

A - Temporary stop
Wind up the cable and fasten it to the machine
not leave it exposed to atmospheric agents and
persons.
To disconnect from the main power supply, consult
qualified personnel.
B - Definitive stop
disposal or to second-hand goods dealers.
13. PROBLEMS AND REMEDIES
Check operations to be carried out by the
user with the plug disconnected.
For any type of problem or inconvenience
not specifically indicated, disconnect the
plug and contact our service centre without
attempting any direct repairs.
A) The machine does not start:
- check that the plug is connected;
- In case of power failure wait for the power to return
and check if the earth leakage protection circuit
breaker or the main switch is on;
- check the condition of the plug and the supply
personnel.
B) There is water under the machine:
- check that the drainage tray is not obstructed.
C) Slow dispensing:
- check that the filters and delivery heads are
clean;
- check that the nozzles are not obstructed.
-