Connections; Operation; Controls; Control Instruments - Rancilio epoca Use And Maintenance

differential switch (Fig. 6) at the start of the power
cable, complete with magnetic release elements in
1). The contacts must have an opening of equal or
over 3 mm and with dispersed current protection of
30 mA.
WARNING:
Should the power supply cable be damaged
it is to be replaced by the manufacturer or by
its technical assistance service or by person
vent any risks.

6.2. Connections

Place the machine on the horizontal sur-
pipes:
sure for several minutes.
Connect the machine to the socket.
sure.
up to the level set.
Switch on main switch 2 to begin heating the water
in the boiler.
Operate each unit in order to allow the water to
twice.
Deliver steam from the steam jets for about one
minute.
operation twice.
Switch off switches 1 and 2.
IMPORTANT
Should the machine not deliver water for over
24 hours, wash the internal components be-
fore beginning work, repeating the operations
as described above
ATTENTION
Please be informed that in order to avoid
1.25 mm.
If, during the installation, the machino get in
security mode (the on/off selection on the
the main switch.
54

7. OPERATION

7.1. Controls (Fig.6)
1 Main switch.
Two-position switch with led.
Turn on the switch, led on, the machine is turned
(apart from the boiler) and the pump is turned on
2 Boiler resistance switch.
Two-position switch with led.
On activating the switch, the led comes on, and
power is supplied to the resistance for the boiler
water.
-
3 Coffee dispenser switch (mod. S1 - S1 TANK)
On pressing the button, continuous coffee dispen-
sing begins and the led comes on.
and the led goes out.
4 Electronic coffee delivery button panel.(mod.
E1). Five buttons with relative led:
A
Press the button for a second, led on, release
The led turns off and dispensing ceases.
-
B
Press the button for a second, led on, release
the same unit.
The led turns off and dispensing ceases.
C
Press the button for a second, led on, release
-
The led turns off and dispensing ceases.
D
Press the button for a second, led on, release
from the same unit.
The led turns off and dispensing ceases.
E
Press the button for a second, led on, release
Press the button for a second, led off, release
A-B-C-D, hold button E down until the relative
led turns off.
5 Hot water supply tap
Tap: turn in an anticlockwise direction to open and
clockwise to close.
6 Steam supply handwheel.
Tap: turn in an anticlockwise direction to open and
clockwise to close.
7.2. Control instruments (Fig.6)
7 Gauge
scale and colour indicator areas.
Visual control of the boiler pressure.
8 Boiler water level indicator
9 Tank water level indicator (Mod.S1 TANK)