Preparing Cappuccino; Warming A Beverage; Preparing Tea, Camomile, Etc; Adjustments And Settings Of The Dose - Rancilio epoca Use And Maintenance

8.2. Preparing cappuccino (Fig.8)
Make cup of cappuccino with the express coffee.
Place the jug under the spout so that the nozzle
touches the bottom.
Turn on the steam tap (6 - Fig.6) and lower the jug
so that the nozzle is almost at the surface of the
milk.
the nozzle moves in and out of the milk, causing
it to froth.
Turn off the steam tap and pour the milk into the
cup.
Immediately after carrying out this operation,
clean the spout with a sponge or a clean
cloth so that the milk does not dry on it. Be
careful as the spout is hot and may burn
your hand.
8.3. Heating a beverage
Immerse the steam spout into the liquid to be
heated.
steam that bursts in the liquid heats it to the desired
temperature.
Turn off the steam tap when the desired tempera-
ture has been reached.
Immediately after carrying out this operation,
clean the spout with a sponge or clean cloth.
Be careful as the spout is hot and may burn
your hand.

8.4. Preparing tea, camomile, etc.

Place the jug under the hot water spout and turn
been obtained, turn off the tap.
Add the beverage desired.
assume a darker colour.
Should the user prefer a lighter coloured drink, draw
fresh water from an ordinary tap and proceed with
the heating phase as described in point 8.3.
56
9. ADJUSTMENT AND SETTING OF THE
DOSE (where available)
9.1. Models E1
It is possible to adjust the dose of coffee dispensed
E1 models.

9.1.1. Adjusting the dose

sure.
1 Press the button E on the panel and hold it down
the dispensing unit and the led of the continuons
der to reach the correct coffee amount adjustment
in the cup.
unit and the cup under the spout.
4 Operate the selected button (i.e. button A for one
small cup).
5 One the required coffee amount in the cup has
been reached, press the stop button E. Coffe will
stop pouring and the microprocessor will store the
dose.
6 Press the continuous button E
7 Make the coffee and check the cup amount in order
to check that programming is correct.
If some doses have to be changed (B-C-D), once
at point 5 repeat the instructions in points 3-4-5 for
all changed doses.
-
-