Transport; Packaging; Inspection On Receipt; Installation - Rancilio epoca Use And Maintenance

4.1. precautionary measures
kind of product that could damage and pollute it.
The manufacturer cannot be held responsible
for damage to people or things caused by
unsuitable, erroneous or irrational use.

5. TRANSPORT

5.1. Packaging

The machine is delivered in a strong cardboard box
with internal protection.
ved during handling and stocking of the item.
Always keep the package in a vertical position
during transport. Do not turn it over or lay it
on its side and avoid bumping and exposure
to atmospheric agents.

5.2. Inspection on receipt

Check that the machine received corresponds to
accessories.
Check that it has not been damaged during transport
and, if so, inform the forwarder and our customer
The packing elements (plastic bags, expan-
ded polystyrene, nails, cardboard, etc.) must
not be left within reach of children as they are
potential sources of danger. Do not dispose
of the packing elements in the environment;
disposal.

6. INSTALLATION

where use and maintenance is restricted to trained
personnel.
warming surface is at over 150 cm from ground. Do
not use water jets or install where water jets are
used.
In order to guarantee normal operation, the machine
must be installed in areas that the environmental
temperature is between +5°C
of not over 70%.
It does not need to be anchored to the surface and it
It is recommended to leave the area around the ma-
chine free to facilitate its use and the performance
damage to the electric components.
Reserve an area near the machine for the installa-
tion of the coffee grinding and dosage machine (see
relevant documentation).
Should a different softener be installed, refer to the
-
documentation of the relevant product.
A dreg drawer should be fitted by the installer.
6.1. Connections to be made by the
user.
Hook-up must be carried out by qualified
personnel in full accordance with federal,
state and local regulations.
6.1.1. Water supply (Mod.E1 - S1) (Fig.5)
This equipment is to be installed to comply
with the applicable federal, state or local
plumbing codes.
Connections must be installed close to the machine.
Water drainage pipe 1, having a minimum internal
diameter of 30 mm, equipped with a water-trap
accessible for inspection.
Make sure that the maximum supply pressu-
re does not exceed 6.5 bar; otherwise, install
a pressure reducer.
6.1.2. Electric supply
Before connecting the machine ensure that the
distribution network.
connected to the connection provided according to
quirements.
provisions of current legislation.
standards with protective conductor (earthing wire).
conductors (phase + neutral + earth).
-
-
-
53