Table of Contents
Advertisement
4. Remove the side cover and support bracket. (See "Removing the side cover"
on page 15 and "Removing and installing the support bracket" on page 17).
5. Locate the CMOS recovery jumper (JP2) on the system board, removing any
adapters that impede access to the jumper.
CMOS jumper (JP2)
6. Move the CMOS recovery jumper from pins 1 and 2 to pins 2 and 3.
7. Wait 60 seconds; then, return the CMOS recovery jumper to pins 1 and 2.
8. Replace any adapters that were removed; then, replace the support bracket
and replace the side cover. (See "Removing and installing the support bracket"
on page 17 and "Replacing the side cover" on page 38).
You can now start the server one time without having to use the user
password and start the Configuration/Setup Utility program. At this time, you
can either delete the old password or set a new user password. If you do not
change or delete the password, the next time you start the server the original
user password will be reinstated.
9. Connect the server to a power source, keyboard, monitor, and mouse.
10. Turn on the server. The Configuration/Setup Utility program starts.
11. Follow the instructions to erase the existing password or create a new
password.
12. Select Save Settings and press Enter.
Boot block
jumper (JP1)
Chapter 6. Solving problems
69
Advertisement
Table of Contents
