Table of Contents
Advertisement
The following illustration shows the rear connectors on the hot-swap-drive
backplane as seen from the rear of the server drive cage.
Complete the following steps to install a hot-swap hard disk drive:
1. Read the safety information beginning on page vii and the "Installation
guidelines" on page 13,.
2. Unlock the side cover.
3. Slide the drive-bay lock bar to the left to access the drive bays.
4. Remove the filler panel from one of the empty hot-swap bays by inserting your
finger into the depression at the left side of the filler panel and pulling it away
from the server.
5. Install the hard disk drive in the hot-swap bay:
a. Make sure that the tray handle is open (that is, perpendicular to the drive).
b. Align the drive assembly with the guide rails in the bay.
SCSI cable
connector
SCSI power
cable connector
2
I C cable
connector
Chapter 2. Installing options
25
Advertisement
Table of Contents
