Table of Contents
Advertisement
10. Attach the hard disk drive to the drive tray with the four screws that are
attached to the drive tray (use the plastic pins on the drive tray to help line up
the drive with the drive tray screw holes).
11. Align the drive assembly with the guide rails in the bay (the connector end of
the drive goes in first).
12. Gently slide the drive assembly into the drive bay as far as it will go.
13. Connect one end of the SCSI signal cable into the back of the drive and make
sure that the other end of this cable is connected into the SCSI connector on
the system board. See "Power and signal cables for internal drives" on page
32 for additional information about cabling drives and "System-board internal
connectors" on page 9 for the location of the SCSI connectors on the system
board. If there are open connectors on the cables connecting existing SCSI
drives, you can use these cables to connect the new drive.
14. Route the signal cable so that it does not block the airflow to the rear of the
drives or over the microprocessor and memory.
15. Connect the power cable to the back of the drive. The connectors are keyed
and can be inserted only one way.
16. If you have other options to install or remove, do so now. Otherwise, see
"Completing the installation" on page 38..
Chapter 2. Installing options
29
Advertisement
Table of Contents
