Table of Contents
Advertisement
4. Grasp the recess area on the door hatch and rotate the door hatch outward until
it disengages from the server.
Bay 1
Bay 2
Bay 3
Bay 4
Bay 5
Bay 6
Bay 7
5. Touch the static-protective package containing the drive to any unpainted metal
surface on the server; then, remove the drive from the package and place it on
a static-protective surface.
6. Align the drive assembly with the guide rails in the bay (the connector end of
the drive goes in first).
7. Gently slide the drive assembly into the drive bay until the drive attaches to the
back plate connector at the back of the drive bay (you should hear a click).
Note: If you install a drive in bay 4, you will have to cable it as you would
normally cable a non-hot-swap hard disk drive.
8. If you have other options to install or remove, do so now. Otherwise, see
"Completing the installation" on page 38.
Recess area
Door hatch
Chapter 2. Installing options
31
Advertisement
Table of Contents
