Expansion-slot
cover
Rear adapter-
retaining
bracket
10. Connect required cables to the adapter. Route cables so that they do not block
the flow of air from the fans. If you are installing an optional SCSI adapter, see
"Cabling an optional SCSI adapter" on page 36 for additional information.
11. If you have other options to install or remove, do so now.
12. If you have installed a full-length adapter, rotate the front adapter-support
bracket to the closed (locked) position.
13. Reinstall the rear adapter-retention bracket; then, rotate the bracket to the
closed (locked) position.
Note: If any adapters in your server are large or have heavy cables attached
to them, you can remove the rear adapter-retention bracket and secure
all of the adapters with expansion-slot screws. The expansion-slot
screws are stored on the frame-support bracket.
14. Replace the frame-support bracket. See "Removing and installing the support
bracket" on page 17; then, go to "Completing the installation" on page 38.
Adapter
Front adapter-
support bracket
Chapter 2. Installing options
35