Table of Contents
Advertisement
Memory installation sequence
DIMMs
1 DIMM
2 DIMMs
4 DIMMs
Note: You can install 1, 2, or 4 DIMMs in your server, but not 3 DIMMs. It is not supported.
Attention:
To avoid breaking the retaining clips or damaging the DIMM
connectors, open and close the clips gently.
6. Open the retaining clips and, if necessary, remove any existing DIMM.
7. Touch the static-protective package containing the DIMM to any unpainted
metal surface on the server. Then, remove the new DIMM from the package.
8. Turn the DIMM so that the DIMM keys align correctly with the slot.
9. Insert the DIMM into the connector by aligning the edges of the DIMM with the
slots at the ends of the DIMM connector. Firmly press the DIMM straight down
into the connector by applying pressure on both ends of the DIMM
simultaneously. The retaining clips snap into the locked position when the
DIMM is firmly seated in the connector. If there is a gap between the DIMM
and the retaining clips, the DIMM has not been correctly installed. Open the
retaining clips, remove the DIMM, and then reinsert it.
10. If you have other options to install or remove, do so now; otherwise, replace
the support bracket (see "Removing and installing the support bracket" on
page 17) and go to "Completing the installation" on page 38.
Slots
1
1, 3
1, 2, 3, 4
DIMM 4
DIMM 3
DIMM 2
DIMM 1
Chapter 2. Installing options
19
Advertisement
Table of Contents
