Adjusting The Sound; Personalizing The Projector Menu Display - BenQ MP776 User Manual

Adjusting the sound

Adjusting the sound Adjusting the sound Adjusting the sound
The sound adjustments made as below will have an effect on the projector speakers. Be sure
you have made a correct connection to the projector audio input. See
18 for how the audio input is connected.
Muting the sound Muting the sound Muting the sound Muting the sound
To temporarily turn off the sound:
1. Press MENU/EXIT MENU/EXIT MENU/EXIT MENU/EXIT and then press
is highlighted.
2. Press to highlight Audio Settings
page displays.
3. Highlight Mute Mute and press
Mute Mute
Adjusting the sound level Adjusting the sound level Adjusting the sound level Adjusting the sound level
To adjust the sound level, press Volume +/-
1. Repeat steps 1-2 above.
2. Press to highlight Volume
sound level.
Turning off the Power on/off ring tone Turning off the
Turning off the Turning off the
To turn off the ring tone:
1. Repeat steps 1-2 above.
2. Press to highlight Power on/off ring tone
select Off Off. Off Off
The only way to change Power on/off ring tone is setting On or Off here.
Setting the sound mute or changing the sound level will not affect the
Power on/off ring tone.

Personalizing the projector menu display

Personalizing the projector menu display
Personalizing the projector menu display Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The
following settings do not affect the projection settings, operation, or performance.
• Menu Display Time in the SYSTEM SETUP: Basic Menu Display Time
Menu Display Time Menu Display Time
of time the OSD will remain active after your last key press. The time length ranges from
5 to 30 seconds in 5-second increments. Use
• Menu Position in the SYSTEM SETUP: Basic Menu Position
Menu Position Menu Position
position in five locations. Use
• Language in the SYSTEM SETUP: Basic Language
Language Language
Screen (OSD) Menus. Use
• Splash Screen in the SYSTEM SETUP: Basic Splash Screen
Splash Screen Splash Screen
displayed during projector start-up. Use
Audio Settings and press MODE/ENTER
Audio Settings Audio Settings
/ to select On
Volume +/- on the remote control, or:
Volume +/- Volume +/-
Volume and press
Volume Volume
Power on/off ring tone
Power on/off ring tone Power on/off ring tone
Power on/off ring tone and press
Power on/off ring tone Power on/off ring tone
SYSTEM SETUP: Basic > Menu Settings
SYSTEM SETUP: Basic SYSTEM SETUP: Basic
SYSTEM SETUP: Basic > Menu Settings
SYSTEM SETUP: Basic SYSTEM SETUP: Basic
/ to select a preferred position.
SYSTEM SETUP: Basic menu sets your familiar language for the On-
SYSTEM SETUP: Basic SYSTEM SETUP: Basic
/ to select your language.
SYSTEM SETUP: Basic menu sets a preferred logo screen to be
SYSTEM SETUP: Basic SYSTEM SETUP: Basic
http://www.pureglare.com.au
/ until the SYSTEM SETUP: Advanced SYSTEM SETUP: Advanced SYSTEM SETUP: Advanced SYSTEM SETUP: Advanced menu
MODE/ENTER. The Audio Settings
MODE/ENTER MODE/ENTER
On.
On On
/ to select a desired
/
Menu Settings menu sets the length
Menu Settings Menu Settings
/ to select a suitable time.
Menu Settings menu sets the OSD
Menu Settings Menu Settings
/ to select a screen.
"Connection" on page
Audio Settings
Audio Settings Audio Settings
to
Operation 39