Bobbin Winding; Inserting The Bobbin - Husqvarna VIKING Onyx 15 User Manual

BOBBIN WINDING

A
B
1. Place the thread spool on the spool pin. Slide a spool cap
firmly against the spool.
2. Place the thread into the thread guide (A) from front to the
back. Bring the thread clockwise around the bobbin
winding tension disc (B), making sure that the thread is
pulled snuggly between the discs.
3. Thread through the hole in the bobbin (C) from the inside
to the outside.
4. Place the bobbin on the bobbin winding spindle. Make
sure the bobbin is pushed down firmly.
5. Push the bobbin winding spindle to the right. Hold the
Note: When the bobbin winding spindle is pushed to the right, the machine will not sew. Make sure to push the bobbin spindle back to the sewing position
(left) before sewing.

INSERTING THE BOBBIN

Make sure that the needle is fully raised and the machine is
turned off before inserting or removing the bobbin.
1. Open the bobbin cover by pushing the release button to
the right (A). Remove the cover (B).
2. Insert the bobbin in the bobbin case with the thread
running in a counterclockwise direction.
3. Draw the thread at the arrow markings into the stitch
plate thread guide from (C) to (D).
4. Pull the thread at the arrow markings into the stitch plate
thread guide from (D) to (E). To cut off excess thread
pull thread back over the cutting off blade at point (E).
Close the bobbin cover plate.
5. Replace the bobbin cover.
thread end, and press the foot control to start winding.
After a few turns, take your foot off the foot control to
stop winding. Cut the excess thread tail above the bobbin,
making sure to trim it close to the bobbin. Step on the foot
control to resume winding. When the bobbin is full, the
bobbin winding will slow down and stop automatically.
6. Push the bobbin winding spindle to the left. Remove the
bobbin and cut the thread.
1
B
A
3
D
C
5
C
2
4
E
Preparations – 11